Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SRP541W advanced Firewall

HI. I have a SRP541W Router. we are getting alot of SIP attackes on port 5060.  

We have port 5060 forwarded to our PBX internaly.

I would like to configure the firewall so that only specific IP addresses are alowed through everything else is blocked.

I also dont want to block out IPsec traffic.

What would I need to enter in the chart below?

Rule Name:
Status: Enabled  Disabled
Interface:IN Interface(WAN):  Out Interface(LAN): 

Source IP Address: . . .
Source Subnet Mask: . . .
Destination IP Address: . . .
Destination Subnet Mask: . . .
Protocol:
Source Port: to
Destination Port: to
Action:

Schedule  Everyday   Sun   Mon   Tue   Wed   Thu   Fri   Sat
Times:24 Hours Range
Everyone's tags (3)
1 REPLY
New Member

I'm wondering if it was

I'm wondering if it was resolved. I have the same issue, i'm getting millions of attempt registration over 5060. I even setup a fw rule to block traffic from that source but it's still getting in. Is it that port forwarding takes precedence over fw rules??

159
Views
0
Helpful
1
Replies
CreatePlease login to create content