Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Static nat one to many question

Hope someone can help with this.                 

I have a requirment to allow a vendor access to a lot of devices on a subinter face DMZ which I created just for their devices.

However I only have one public address left to allow access from the outside.

They need specific udp and tcp ports open depending on which device they are accessing. I created object-group service config for all the ports but not sure how to actually allow the outside access into the DMZ.

Example

device 192.168.13.6 needs access both ways on udp ports 18810,18803,18801 and 18001. And this same device needs access both ways on tcp port18802.

And device 192.168.13.2 needs another set of udp and tcp ports open.

All of the devices have variations like this.

What is the correct static nat config to allow the vendor access from outside to many addr in this DMZ?

Everyone's tags (5)
1 REPLY
New Member

Static nat one to many question

I forgot to mention that we are running 8.2 code on 5510.

269
Views
0
Helpful
1
Replies