Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Static NAT problem

All,

I have a problem in that I have multiple IP addresses that get redirected to the same internal host.....on the same port.

I can't do:

static (dmz1,outside) x.x.x.x x.x.x.x netmask x.x.x.x

And I can't do:

static (dmz1,outside) tcp x.x.x.x port x.x.x.x port netmask 255.255.255.255

Can I do anything for this?

Thanks,

John

HTH, John *** Please rate all useful posts ***
1 ACCEPTED SOLUTION
5 REPLIES
Hall of Fame Super Blue

Re: Static NAT problem

John

I don't think you can do this with the ASA. If the source addresses were different depending on the public IP address being accessed then you could do something but if this isn't the case i don't think the ASA will let you configure this.

Jon

Hall of Fame Super Blue

Re: Static NAT problem

Vikram

Many thanks for this. I was involved in that post too so i should have remembered :-)

John

Apologies, totally forgot about that post, your memory goes as you get older :-).

Jon

Re: Static NAT problem

no worries JON, we all make mistakes :).

Re: Static NAT problem

Jon,

I submitted a tac case yesterday, and they said that it was impossible.

I just tested this on my ASA at the house, and it works great. =)

Thanks Jon and Vikram!

John

HTH, John *** Please rate all useful posts ***
119
Views
5
Helpful
5
Replies
CreatePlease login to create content