Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)

static nat

A customer has two sites connected via a metro-e link. They are requesting that a video conference unit at the remote site utilize a public ip address. The video traffic comes into the main site and then crosses the metro-e to the video unit. Will the following command take care of it.

ip nat inside source static 10.x.x.229 63.x.x.229

Thank you in advance!

1 REPLY

Re: static nat

The command will configure a static NAT entry which map the internal/local IP 10.x.x.229 to external/global IP 63.x.x.229. If this is what you wnats, the answer is "yes". You also need configure "ip nat outside" and "ip nat inside" under related interface.

111
Views
5
Helpful
1
Replies
CreatePlease to create content