04-03-2008 08:03 AM - edited 03-11-2019 05:26 AM
ASA5520 being used as isolation device only.
Groups wants multiple statics translations setup to allow access from inside to outside via RDP......is there a way to do "auto" static translation for many ip addresses? or do i need to enter each static translation by hand?
192.168.1.1 > 10.168.1.1
192.168.1.2 > 10.168.1.2
etc
etc
192.168.1.254 > 10.168.1.254
Solved! Go to Solution.
04-04-2008 10:21 AM
Cisco not support IP Shift NAT, see the thread below:
Netscreen can do this.
04-03-2008 10:38 PM
You can write only one static, like this :
static (outside,inside) 192.168.0.0 10.168.0.0 netmask 255.255.0.0 0 0
04-04-2008 10:21 AM
Cisco not support IP Shift NAT, see the thread below:
Netscreen can do this.
04-04-2008 03:47 PM
Glad it was helpful, thanks for rating.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: