Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Step to prep CSC SSM on ASA Active/Standby mode

Hi all, 

I am trying to setup Active/Standby HA mode for my site.

Currently the site was installed with one unit ASA firewall with CSC-SSM module, the second unit is the new unit ready to be setup.

My question:

01. My concern is second unit CSC-SSM, what is the proper procedure or step need to prep it?

Is it need to prep the CSC-SSM before the ASA in HA mode Or it will auto propagate the configuration when both unit in HA mode?

What else need to concern? am i need to setup different IP for the CSC-SSM management interface?

Thanks

Noel

1 REPLY

Step to prep CSC SSM on ASA Active/Standby mode

Hello Yong,

Configuration related to the CSC or SSM modules will never get propagated so you will basically need to configure it manually.

Also it's not like if the Config on both modules is different failover will fail but ofcourse you wanna have the same one

IP addresses for each of the modules will be dedicated ones. Remember that failover will fail if one box has the CSC and the other not.

Looking for some Networking Assistance? 
Contact me directly at jcarvaja@laguiadelnetworking.com

I will fix your problem ASAP.

Cheers,

Julio Carvajal Segura
http://laguiadelnetworking.com

Looking for some Networking Assistance? Contact me directly at jcarvaja@laguiadelnetworking.com I will fix your problem ASAP. Cheers, Julio Carvajal Segura http://laguiadelnetworking.com
151
Views
0
Helpful
1
Replies
CreatePlease login to create content