cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
315
Views
0
Helpful
1
Replies

Step to prep CSC SSM on ASA Active/Standby mode

yong khang NG
Level 5
Level 5

Hi all, 

I am trying to setup Active/Standby HA mode for my site.

Currently the site was installed with one unit ASA firewall with CSC-SSM module, the second unit is the new unit ready to be setup.

My question:

01. My concern is second unit CSC-SSM, what is the proper procedure or step need to prep it?

Is it need to prep the CSC-SSM before the ASA in HA mode Or it will auto propagate the configuration when both unit in HA mode?

What else need to concern? am i need to setup different IP for the CSC-SSM management interface?

Thanks

Noel

1 Reply 1

Julio Carvajal
VIP Alumni
VIP Alumni

Hello Yong,

Configuration related to the CSC or SSM modules will never get propagated so you will basically need to configure it manually.

Also it's not like if the Config on both modules is different failover will fail but ofcourse you wanna have the same one

IP addresses for each of the modules will be dedicated ones. Remember that failover will fail if one box has the CSC and the other not.

Looking for some Networking Assistance? 
Contact me directly at jcarvaja@laguiadelnetworking.com

I will fix your problem ASAP.

Cheers,

Julio Carvajal Segura
http://laguiadelnetworking.com

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: