Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

sub-networks

my main network is 10.9.2.XXX

i have sub networks ie. 10.2.x.x, 10.3.x.x, 10.4.x.x, and so on!

if i log into the 10.9.2.x network i can go into any sub network.

but if i connect my laptop to ANY sub network of course my ip gets that sub networks ip. but i cannot talk to another sub network.

ie. if i am on network 10.2.x.x and i want to print to the printer on 10.6.x.x i cannot?

any ideas?

I have attached a subnetworks config...

6 REPLIES

Re: sub-networks

I assume that all have the same security level

the command below will allow communication between the subnets.(but it will support only on IOS 7.0 and above)

hostname(config)# same-security-traffic permit inter-interface

New Member

Re: sub-networks

does this line need to go into the main 506 and all my 501 that connect to the 506?

Re: sub-networks

It will be on the box on which the subinterfaces are created.

New Member

Re: sub-networks

ok well i am understanding that i eed to place this line in my 506E. Thats the 1 that all the 501's VPN into to create the vpn tunnel!

So i guess i need to update my pix506E to ios 7.0.

is taht coirrect?

New Member

Re: sub-networks

is this feature NOT avalable in 6.3.5?

New Member

Re: sub-networks

is there a way i can accomplish this with the current 6.3.5 IOS i have loaded?

118
Views
0
Helpful
6
Replies