Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

syncing configs

Hi,

 

I've configured  firewall 1 by pasting in the config from the existing firewall that I will be replacing. Now I want to sync the config with firewall 2. What must I configure on Firewall 2 to make this happen when I attach the firewalls over the failover link?

 

Thank you, Pat.

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Assuming you have a failover

Assuming you have a failover-capable license and are building an active-standby failover pair, you only need setup the failover interface on the secondary ASA and tell it it's in a pair with the global "failover" command.

Reference.

2 REPLIES
Hall of Fame Super Silver

Assuming you have a failover

Assuming you have a failover-capable license and are building an active-standby failover pair, you only need setup the failover interface on the secondary ASA and tell it it's in a pair with the global "failover" command.

Reference.

hi patrik,marvin is right.

hi patrik,

marvin is right. assuming you're using active-standby failover, you'll just need to configure the failover interface on your firewall 2.

more info can be found on this link:

http://ccnpsecuritywannabe.blogspot.com/2013/12/active-standby-failover-on-asa.html

56
Views
5
Helpful
2
Replies
CreatePlease to create content