Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

Syslogging

Has anyone experienced problems changing the logging severity level of a Syslog ID to either raise or lower its level within the ASDM?  I want to log certain activities that are currently set as notification and informational but don't want to log everything at that level.  I thought that I might try changing the severity level of the IDs I want to capture as a work around, any suggestions?  Thank you.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Syslogging

Hi James

what do you want to log here ? Some specific traffic (info or notifications ) ? If so, see if this URL helps you:

http://www.ciscopress.com/articles/article.asp?p=424447&seqNum=3

It basically talks about pruning certain log messages and customizing your log messages.. if you want specific logging from a source to destination, your ASA access-lists can include "log" keyword which can show you similar outputs..

Hope this helps.. all the best


Raj

2 REPLIES

Re: Syslogging

Hi James

what do you want to log here ? Some specific traffic (info or notifications ) ? If so, see if this URL helps you:

http://www.ciscopress.com/articles/article.asp?p=424447&seqNum=3

It basically talks about pruning certain log messages and customizing your log messages.. if you want specific logging from a source to destination, your ASA access-lists can include "log" keyword which can show you similar outputs..

Hope this helps.. all the best


Raj

New Member

Re: Syslogging

I finally got a chance to take a look at the link and found what I needed.  Thank you.

237
Views
0
Helpful
2
Replies
CreatePlease to create content