cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
241
Views
0
Helpful
1
Replies

Telnet quits after 24-48 hours on equip tied to Cisco 2950 IOS v12.1

kpragash3113
Level 1
Level 1

We have a DACS unit made by an Asian Telecom company whose E-Net port is not user-configurable. Always does 10/100 auto-negotiate. Dozens are installed and working fine. We have two that are tied to two seperate 2950's using IOS v12.1 and after 48 hours or so, we can no longer telnet in to these devices. You can ping the unit, and you can get in via serial port. DACS units have been replaced to no avail. Any suggestions?

1 Reply 1

gmarogi
Level 5
Level 5

There might be a time out for the telnet session, check the configuration of your switch and as well as the DACS unit also.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: