Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Telnet quits after 24-48 hours on equip tied to Cisco 2950 IOS v12.1

We have a DACS unit made by an Asian Telecom company whose E-Net port is not user-configurable. Always does 10/100 auto-negotiate. Dozens are installed and working fine. We have two that are tied to two seperate 2950's using IOS v12.1 and after 48 hours or so, we can no longer telnet in to these devices. You can ping the unit, and you can get in via serial port. DACS units have been replaced to no avail. Any suggestions?

1 REPLY
Bronze

Re: Telnet quits after 24-48 hours on equip tied to Cisco 2950 I

There might be a time out for the telnet session, check the configuration of your switch and as well as the DACS unit also.

105
Views
0
Helpful
1
Replies
CreatePlease login to create content