Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Timeout troubles...

Me again,

Still having a bit of difficulty in the arena of configuring a PIX to replace failing hardware. I've gotten most everything else resolved, however, I'm in a bind with a unneeded timeout entry.

These are the entries I have when I run "show timeout":

timeout xlate 3:00:00

timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 rpc 0:10:00 h225 1:00:00

timeout h323 0:05:00 mgcp 0:05:00 sip 0:30:00 sip_media 0:02:00

timeout sip-disconnect 0:02:00 sip-invite 0:03:00

timeout uauth 0:05:00 absolute

The new PIX is pushing IOS version 6.3(5) and the entry I'm looking to remove (not listed in the current PIX's config) is the one:

"timeout sip-disconnect 0:02:00 sip-invite 0:03:00"

Any advice will help... Thanks in advance!

1 REPLY
New Member

Re: Timeout troubles...

Those are defaults I do not 'think' they can deleted permanently, not sure why it would matter if your security policy does not permit these protocols these values are never used.

130
Views
0
Helpful
1
Replies