I have a bit of a problem where i have to configure an existing transparent 5520 asa to an active/active setup. Never done active/active before but i understand i have to create contexts etc. However Im not sure how this will work on transparent firewalls as i understand that the interfaces on each contexts need adressing(standby/backup).
Is there any other way active/active is achieved in transparent mode? Im tearing my hair out with this one so even a hint of help is greatly appreciated. Thanks
info: routers setup in hsrp on the inside interface and outside interaface.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...