Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

transparent mode Firewall with 4 ports transparent mode Firewall with 4 por

Dears,

i have Firewall with 4 ports FE is configured as transparent mode..... how many interfaces i can configure in this mode.

i heared just one output interface and one input interface i can configure in this mode...is that true?

or can i configure 2 FE as output and 2 FE as Input.

thx for any advice or help.

4 REPLIES
New Member

Re: transparent mode Firewall with 4 ports transparent mode Fire

Hi,

Kindly provide the software and hardware details of your firewall.

regards

Sachin Verma

New Member

Re: transparent mode Firewall with 4 ports transparent mode Fire

it is ASA5510 and software ASA Version 7.2(2) .

New Member

Re: transparent mode Firewall with 4 ports transparent mode Fire

Hi,

Dou you have info about this ?

Can you configure only 2 or 4 interfaces ?

Regards

New Member

Re: transparent mode Firewall with 4 ports transparent mode Fire

Greetings,

Accoding to the ASA manual:

Note Transparent firewall mode allows only two interfaces to pass through traffic; however, on the The ASA 5510 and higher adaptive security appliance, you can use the Management 0/0 interface (either the physical interface or a subinterface) as a third interface for management traffic. The mode is not configurable in this case and must always be management-only.

Also if you desire yopu can configure your device in multiple context mode and use all 4 interfaces. 2 for each context.

Hope this helped.

149
Views
0
Helpful
4
Replies