Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Trying to get a TFTP session going..

So I am trying to upgrade a PIX 515E to 7.0 from 6.3. I blew away the config and plugged in a little 4 port switch into eth1 on the PIX and on the other side there is a laptop.

The laptop is 192.168.1.5 and I configured the PIX through the interactive prompts to 192.168.1.4. I cannot ping between the two.

Anything that I am doing obviously wrong here? Thanks all.

3 REPLIES

Re: Trying to get a TFTP session going..

name the e1 interface as "inside" and enable it.

HTH>

New Member

Re: Trying to get a TFTP session going..

Did that already.

eth1 "inside" is up and line protocol is up.

Any other ideas?

Re: Trying to get a TFTP session going..

check the show arp on the pix, make sure the firewall on the PC is disabled.

If the above is OK - post the config, with the output of "show route" and "show interface"

116
Views
0
Helpful
3
Replies