cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1734
Views
0
Helpful
5
Replies

unable to boot an image

bmckean
Level 1
Level 1

I'm getting the following error msg when booting.

No images in /

Error 15: File not found

unable to boot an image

So I'm trying to use tftp in rommon mode but I can not ping anything from either ASA -> laptop or the other direction. I'm not sure I have correct SET variables in rommon mode.

See attached for details on the error as well as the exact steps I have taken so far.

Bernie

Can anyone help?

5 Replies 5

lm20ele
Level 1
Level 1

Does your laptop have the right ip address assigned?? If you laptop is your tftp shouldn't you have to assign 10.10.1.2?

opps, that was a typo on the document I created. The laptop has the correct address which is 10.10.10.2

I made the following changes:

GATEWAY=10.10.10.2

IMAGE=asa804-23-k8.bin

I successfully tftp the image and booted the asa. I did a write mem and reload and it boots back to rommon mode.

So I then, erased disk0: and tried again with same results.

I then downloaded a different image from cisco.com and get the same results.

see the attachment…

bmckean
Level 1
Level 1

show ru

ciscoasa# show running-config boo

ciscoasa# show running-config boot

ciscoasa# dir

Directory of disk0:/

1374 drw- 0 10:27:14 Mar 30 2009 crypto_archive

1368 drwx 0 10:27:01 Mar 30 2009 log

0 bytes total (0 bytes free)

ciscoasa# dir ?

/all List all files

/recursive List files recursively

all-filesystems List files on all filesystems

disk0: Directory or file name

disk1: Directory or file name

flash: Directory or file name

system: Directory or file name

ciscoasa# dir disk0: fla

ciscoasa# dir flash:

Directory of disk0:/

1374 drw- 0 10:27:14 Mar 30 2009 crypto_archive

1368 drwx 0 10:27:01 Mar 30 2009 log

0 bytes total (0 bytes free)

ciscoasa# dir sys

ciscoasa# dir system:

Directory of system:/

1 ---- 0 00:00:00 Jan 01 1970 running-config

No space information available

ciscoasa# dir disk0:

Directory of disk0:/

1374 drw- 0 10:27:14 Mar 30 2009 crypto_archive

1368 drwx 0 10:27:01 Mar 30 2009 log

I got it working.

After performing the rommon/tftp steps listed above, booted the image:

1. formatted flash again

2. configured the asa int and gateway

3. copy tftp: flash:

4. write mem

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: