Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Unable to configure interface ASA 5510

I am having a problem configuring any interface on my ASA 5510 running ASA 8.2.1. When i try to configure an interface I am unabl eto assign an IP addres, security level, name the interface or do anythingt else that would allow me to use the device. When I hit the "?" to see the allowed command I recieve the following:

corpfir01(config)# interface ethernet 0/1

corpfir01(config-if)# ?

Interface configuration commands:
  default      Set a command to its defaults
  description  Interface specific description
  dhcp         Configure parameters for DHCP client
  duplex       Configure duplex operation
  exit         Exit from interface configuration mode
  help         Interactive help for interface subcommands
  no           Negate a command or set its defaults
  shutdown     Shutdown the selected interface
  speed        Configure speed operation
corpfir01(config-if)#

Any help is greatly appreciated

3 REPLIES
Cisco Employee

Re: Unable to configure interface ASA 5510

Hmm...Are you logged in with priv 15 account?

issue "sh curpriv" and make sure

what does "sh firewall" say?

Do you have it as transparent firewall?

If so, change it back to routed mode and you can assign ip address to the interface.

no firewall transparent

-KS

New Member

Re: Unable to configure interface ASA 5510

corpfir01# sh firewall
Firewall mode: Router

New Member

Re: Unable to configure interface ASA 5510

Resoloved by issuing:
mode single and rebooting

432
Views
0
Helpful
3
Replies
CreatePlease to create content