unable to connect ASA 5510 through hyperterminal console in Win-XP SP2
I am facing problem, unable to connect ASA5510 through hyperterminal console. OS platform Windows XP SP2. But I can connect all other router and switches. Only ASA 5500 series can not b connected. I get junk charater set on display when I connect ASA5500 through hyperterminal.
Re: unable to connect ASA 5510 through hyperterminal console in
Hi .. try creating a new HypeTerminal session with the below parameters and test it again .. if still does not work then try using a different PC .. It sounds like HyperTerminal might not be configured correctly ..
"Step 2 Before connecting a computer or terminal to the ports, check to determine the baud rate of the serial port. The baud rate must match the default baud rate (9600 baud) of the Console port of the adaptive security appliance. Set up the terminal as follows: 9600 baud (default), 8 data bits, no parity, 1 stop bits, and Flow Control (FC) = Hardware. "
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...