Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

unable to ping remote peer network from site to site vpn

Hi all,

I have a site to site vpn establish between 2 office using a asa5510 and a pix515. On both firewall i set "management-access inside" which suppose to allow me to use the firewall interface to ping the protected private network of the remote peer. I could do this on my asa5510 but could not do the same on my pix515. Pls advise what other settings is required of my pix. Thks in advance.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: unable to ping remote peer network from site to site vpn

Are you trying to ping the PIX inside interface, or you are trying to initiate ping from PIX inside interface?

If you are trying to ping the PIX inside interface, pls make sure that you don't have icmp blocks on the inside interface. Check the output of "sh run icmp".

If you are trying to ping from the PIX inside interface, the following command will allow ping: ping inside

3 REPLIES
Cisco Employee

Re: unable to ping remote peer network from site to site vpn

Are you trying to ping the PIX inside interface, or you are trying to initiate ping from PIX inside interface?

If you are trying to ping the PIX inside interface, pls make sure that you don't have icmp blocks on the inside interface. Check the output of "sh run icmp".

If you are trying to ping from the PIX inside interface, the following command will allow ping: ping inside

Community Member

Re: unable to ping remote peer network from site to site vpn

Hi jen,

Thks, i am trying to ping from the inside interface of the pix firewall. It works.

Cisco Employee

Re: unable to ping remote peer network from site to site vpn

Perfect, thanks..

893
Views
0
Helpful
3
Replies
CreatePlease to create content