The Lab: pc -> switch1 -> asa -> switch2 -> access point
I configured the devices and after they booted, i can ping all devices from the Pc ( AP, FW, Switch2 behind the asa )
After about 20 Pings i get ping timeout as response.
Then after a while they will come up again and i get a ping response, and the devices will play this game the whole day ;) Sometimes none of them response...
The strange thing ... i can ping all devices from switch1 and i can connect to them threw my switch1 via ssh or telnet. If i connected threw this "switch jumping" i ping my pc from the device behind the asa and then i get a response to my ping which i sent from the pc.
The acl is wiiiide open, permit ip any any.
Any ideas? Something like a X-File Story ;(
Btw. i can ping the asa inside interface continuously
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
[toc:faq]Introduction:This document describes details on how NAT-T
works.Background:ESP encrypts all critical information, encapsulating
the entire inner TCP/UDP datagram within an ESP header. ESP is an IP
protocol in the same sense that TCP and UDP are I...