Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Updating ADSM

Hello,

I'm have upgraded our ASA 5510's from 7.0.8 to 8.4.3 and now I just need to do the ASDM, but get this error?  The bin file has been uploaded:

configure mode commands/options:

  disk0:/asa708-k8.bin    disk0:/asa843-k8.bin     disk0:/asdm-508.bin

  disk0:/asdm-647.bin     disk0:/crypto_archive

ciscoasa(config)# asdm image disk0:/asdm-647.bin

Device Manager image set, but not a valid image file disk0:/asdm-647.bin

What is the problem?

3 REPLIES

Updating ADSM

ASA 8.0(3)

ASDM 6.0(3) and later. Recommended: 6.4(7).

Image is Ok.

Did you change boot parameters?

show run boot

Thanks

Ajay

Community Member

Re: Updating ADSM

If you have done this before rebooting the ASA to the new firmware, this is normal, just reboot it and it should be fine

Sent from Cisco Technical Support iPhone App

Hall of Fame Super Silver

Updating ADSM

Your command and directory filenames look OK.

Is your asdm-647.bin file size ~17,483 KB? If not, you might want to re-download asdm-647.bin from cisco.com and re-copy it onto disk0: (after deleting the current copy).

1102
Views
0
Helpful
3
Replies
CreatePlease to create content