08-13-2007 12:40 PM - edited 03-11-2019 03:57 AM
Can you upgrade both the ASA software and the ASDM software at the same time so that only one reload is needed?
TIA
Greg
08-13-2007 12:53 PM
Absolutely.
08-13-2007 02:11 PM
Yes, from the CLI (assuming you're using TFTP here...if not, adjust your copy command)
Just do two "copy tftp: disk0:/" commands; one for the asa802-k8.bin file and the second for the asdm-602.bin file
Then, (again from the CLI), you can:
boot system disk0:/asa802-k8.bin
asdm image disk0:/asdm-602.bin
write mem
reload
And you're all done... that's all I did to upgrade my five firewalls this past week.
08-13-2007 06:36 PM
you don't need to reload when upgrading any asdm image file, only the OS.
08-14-2007 03:52 AM
I'd like to thank everone for their input. The repsonses were excellent. I was able to sucessfully upgrade last night with only one reload.
Greg
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: