Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Upgrade to asa821-k8 didnt work

Last night I upgraded an ASA 5520 from 8.0.(4) to 8.2.1 it booted fine and seemed to pass traffic fine however any incoming static nat translations didnt work even though they showed up in the ASDM, should I have made any config changes prior to upgrade..any ideas

1 REPLY
Cisco Employee

Re: Upgrade to asa821-k8 didnt work

No, upgrade to 8.0 to 8.2 should work smoothly.

Maybe there was a bogus xlate that got create and caused this issue. I don't know the specifics of the problem, but that could be something that has happened depending on if you have conflicting xlates.

If you had save the config then the upgrade should in general not relate with the problem.

PK

267
Views
0
Helpful
1
Replies