Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Upgrading license key on ASA pair question

I have a license to upgrade my ASA pair.  The license appears to be associated with the serial number of the Secondary (though currently active) ASA.  The question is - to input the new license and have it take effect on both members of the pair is there anything special that needs to be done?  Just install the license on the secondary/active and this will replicate to the primary/standby?  The instructions that came with the key are a little vague not mentioning on what to do with the bundle.

"Installing Your Cisco Adaptive Security Appliance Activation Key

Step 1.  From the command line interface (CLI), enter configuration mode using

the "conf t" command.

Step 2.  Type the "activation-key" command, and then, when prompted, enter the

new activation key listed above."

Any assistance is appreciated.  Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Upgrading license key on ASA pair question

No, you would need to purchase exactly the same upgrade license for the other ASA (in your case, serial# of the primary).

If you just enter the activation key into the secondary active firewall, it will break (turn off) the failover automatically, because one of the requirement for failover to have exactly the same license on both ASA.

And, yes, you are right. License is tied to the serial# of the device, hence, if you have purchased the upgrade license for the secondary ASA serial#, you would need to purchase the same upgrade license for the primary ASA serial#.

Hope that helps.

2 REPLIES
Cisco Employee

Re: Upgrading license key on ASA pair question

No, you would need to purchase exactly the same upgrade license for the other ASA (in your case, serial# of the primary).

If you just enter the activation key into the secondary active firewall, it will break (turn off) the failover automatically, because one of the requirement for failover to have exactly the same license on both ASA.

And, yes, you are right. License is tied to the serial# of the device, hence, if you have purchased the upgrade license for the secondary ASA serial#, you would need to purchase the same upgrade license for the primary ASA serial#.

Hope that helps.

New Member

Re: Upgrading license key on ASA pair question

Ouch.  Looks like this one got past our VAR.  Very helpful to know this ahead of the change however!   Thank you.

1189
Views
0
Helpful
2
Replies
CreatePlease to create content