Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

upgrading PIX 6.1(3) to 6.3(5)

Dear all,

i need to upgrade software as in the subject.

i need the steps as well as configuartion file changes.

Thanks,

5 REPLIES

Re: upgrading PIX 6.1(3) to 6.3(5)

New Member

Re: upgrading PIX 6.1(3) to 6.3(5)

Upgrading from 6.1 to 6.3 wouldn't have any configuration changes.

1) Save the config to tftp server

pixfirewall# write net "ip add":pixconfig

2) Copy the bin file frm tftp to pix

pixfirewall#copy tftp flash

Address or name of remote host [127.0.0.1]? "IP add of tftp server"

Source file name [cdisk]? pix635.bin

3) reload the pix

pixfirewall#reload

if failover is configured on the box.

use #no failover

upgrade on pri, secondary unit

after upgrading on both units issue #failover

HTH

New Member

Re: upgrading PIX 6.1(3) to 6.3(5)

i need to know how to convert the configuration file :

for example,

  conduit permit tcp host x.x.x.x eq www any

to be aplicable on 6.3(5)

New Member

Re: upgrading PIX 6.1(3) to 6.3(5)

New Member

Re: upgrading PIX 6.1(3) to 6.3(5)

ex:

where access list 101 is your outside access list.

access-list 101 permit tcp any host 62.192.84.90 eq www

419
Views
0
Helpful
5
Replies