Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

upgrading Pix from 6.3 to 7.0

Hi

I have a cisco pix 506E and i'm trying to upgrade to the new 7.0 software.But when i try to upgrade i get this message

Address or name of remote host [0.0.0.0]? 10.x.x.x

Source file name [cdisk]? pix708-6.bin

copying tftp://10.x.x.x/pix708-6.bin to flash:image

[yes|no|again]? yes

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Received 5548032 bytes

Erasing current image

Insufficient flash space available for this request:

Size info: request:5468216 current:2052152 delta:3416064 free:2883584

Image not installed

and when i do a sh flash i get this

(config)# sh flash

flash file system: version:3 magic:0x12345679

file 0: origin: 0 length:2052152

file 1: origin: 2097152 length:4329

file 2: origin: 0 length:0

file 3: origin: 2228224 length:3123604

file 4: origin: 0 length:0

file 5: origin: 8257536 length:308

so what i want to know is how do i delete all of this so that i can install the new Bin file,because there is no delete command in 6.3 and you can't use the squeeze command either

1 ACCEPTED SOLUTION

Accepted Solutions

Re: upgrading Pix from 6.3 to 7.0

Unfortunately your platform does not support 7.x version, this version is intended for 515E or higher.

4 REPLIES

Re: upgrading Pix from 6.3 to 7.0

Unfortunately your platform does not support 7.x version, this version is intended for 515E or higher.

Community Member

Re: upgrading Pix from 6.3 to 7.0

Thanks very much

Gold

Re: upgrading Pix from 6.3 to 7.0

while not supported, some people have successfully uploaded 7.x code to the 506e's. You have to first remove the PDM image though to make room for it. try google.

Community Member

Re: upgrading Pix from 6.3 to 7.0

Thank you very much

267
Views
0
Helpful
4
Replies
CreatePlease to create content