Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

urgent! can't connect to FWSM

Hi all,

I have Catalyst 6513 + FWSM. Normally, I use the command "session slot 1 process 1" to connect to FWSM, and I only type password "cisco". Now, I create one usename "cisco" and then, I no username cisco. Now, I connect to FWSM and it asks me "username", I don't kown the default username of FWSM, if you know , please help me.

1 REPLY
New Member

Re: urgent! can't connect to FWSM

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/mod_icn/fwsm/fwsm_3_1/fwsm_cfg/mgacc_f.htm#wp1042046

Recovering from a Lockout

In some circumstances, when you turn on command authorization or CLI authentication, you can be locked out of the FWSM CLI. You can usually recover access by restarting the FWSM. However, if you already saved your configuration, you might be locked out.

The default passwd:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/mod_icn/fwsm/fwsm_3_1/fwsm_cfg/start_f.htm#wp1054192

* Step 2 Log in to the FWSM by entering the login password at the following prompt:

hostname passwd:

By default, the password is cisco.

* Step 4 Enter the enable password at the prompt.

By default, the password is blank,

299
Views
0
Helpful
1
Replies