we need to enable uRPF on a Cisco ASA 5585x but looking at the documentation I cannot determine if it runs in loose or strict mode. for IOS devices, there is the option allow-default that indicates loose mode. our ASAs have only a default route to their gateway so i need to ensure that any network that is NOT in the routing table will route. i only want to drop traffic that we specify to a null destination.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...