Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

Using ADSM for FWSM unable to delete the rule

I have a FWSM module installed in my Catalyst 6500 switch. I noticed that when i use ADSM to manage the firewall. I tried to delete the rule for FWSM but it says that the rule is not valid. I found from others it is a bug. How to solve this? Anybody knows?

1 REPLY
Bronze

Re: Using ADSM for FWSM unable to delete the rule

You can use access rules in routed and transparent firewall mode to control IP traffic. An access rule permits or denies traffic based on the protocol, a source and destination IP address or network, and optionally the source and destination ports.

115
Views
1
Helpful
1
Replies
CreatePlease to create content