Is there a way I can manage and configure the ASA5540 using ASDM v5.0 when I change it to transparent mode?
I CLI to the ASA5540 and change it to transparent mode, then I added an IP address to the device with the same subnet where it is connected to the 6509, and I configure G0/0 and G0/1 with their corresponding security levels and issue a no shut, including m0/0. After this, I can't connect to it anymore using the ASDM software.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...