Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Using NAT and PAT together?

ASA is 5540 w/8.3. I have a large inside block of inside address I want to NAT or PAT

to outside addresses.  Is it possible to use a block of outside addresses with NAT with

rollover PAT to the whole range, or is it restricted to roll over to only a single address?

Thanks, Roger

1 REPLY
New Member

Using NAT and PAT together?

Are you looking to do this for outbound connections to the internet?  If so, this is possible to do a nat to a group of IP address and then if that gets all used up, have it roll over to a single IP address for PAT.

226
Views
0
Helpful
1
Replies