i have purchased the standby unit for Failover. but now i need to use that standby unit as active unit some where. but when i passed some commands it dostnt allow. error appears that "in standby unit configuration can't implement"
please any one tel me the exact command to change standby unit to active firewall unit.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...