Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Using SNMP MIB to show active connections on a PIX515e

Hi, is it possible to get the output of the show connections command using an SNMP MIB query from a PIX515e. I have found reference to the below MIB string but this will only display the connection count and not the actual connections themselves.

The cfwConnectionStatTable object table can be accessed from the following path:

.iso.org.dod.internet.private.enterprises.cisco.ciscoMgmt.ciscoFirewallMIB.

ciscoFirewallMIBObjects.cfwSystem.cfwStatistics.cfwConnectionStatTable

Thanks in advance for any advice on this.

Regards

2 REPLIES
Cisco Employee

Re: Using SNMP MIB to show active connections on a PIX515e

This is about the closest you will get to this info in this MIB table

Community Member

Re: Using SNMP MIB to show active connections on a PIX515e

Thanks, I came to the same conclusion!

266
Views
0
Helpful
2
Replies
CreatePlease to create content