Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Using Vonage with a Cisco ASA5505

Hello All,

I recently purchased a Cisco ASA5505 (basic license) for use at home. I also just purchased Vonage for home phone & fax line usage.

While reading the instructions, the Vonage hardware needs to be placed between the cable modem & my internal LAN equipment.

Instead of going with this model, I was curious if anyone knows or could provide details on how to place the Vonage hardware behind the ASA5505?

I don't know if this could be possible by placing the Vonage device into a DMZ port or if there was another way this could be accomplished.

If you can provide a configuration example that would be extremely helpful as well!

Thank you in advance for your assistance!

-- Phil

3 REPLIES
Silver

Re: Using Vonage with a Cisco ASA5505

I'm not sure how vontage works but it probably requires a static translation. You can add something like

static (inside,outside) 1.1.1.2 192.168.1.2 netmask 255.255.255.255

To translate the 1.1.1.1 outside address to the 192.168.1.2 inside address.

New Member

Re: Using Vonage with a Cisco ASA5505

Thank you very much for the suggestion. I am going to try this as soon as I receive the Vonage hardware.

Hopefully I can make this work without having to upgrade my license to allow DMZ functionality, since that is around 500 dollars I think.

-- Phil

New Member

Re: Using Vonage with a Cisco ASA5505

Well I got the device today and was able to setup the Vonage hardware with no problems at all.

When I connected the WAN port of the Vonage device to the ASA, it picked up on it and allowed the SIP ports out with no problems.

The ASA works perfectly with Vonage, no problems at all!

-- Phil

1508
Views
0
Helpful
3
Replies