Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

VPN and http NAT with one public IP address

Hi,

I was wondering if anyone of you knows if it is possible to do remote access ssl vpn configuration (both anyconnect and webvpn) using port 443, and have port 80 nat'ed and redirected into an internal web server, when I only have one public ip address?

I've tried but can't seem to get it to work. So I think one should probably have 2 public ip addresses in order to do the stunt above. Am I right or wrong?

Thanks in advance,

Rasmus

1 ACCEPTED SOLUTION

Accepted Solutions

Re: VPN and http NAT with one public IP address

Yes it's possible - post your config (santised) for review.

HTH>

3 REPLIES

Re: VPN and http NAT with one public IP address

Yes it's possible - post your config (santised) for review.

HTH>

New Member

Re: VPN and http NAT with one public IP address

Hi there,

Thanks for your answer. I discovered the error myself though. I had VLAN blocking enabled - so when I disabled it, it started to work.

BR.

Rasmus

Re: VPN and http NAT with one public IP address

np - glad to help, thanks for the rating.

112
Views
0
Helpful
3
Replies
CreatePlease to create content