Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VPN: Having problems allowing multiple connections

I have two road warriors that have broadband and are able to connect to the vpn with virtually no problems but when a third user who has a verizon card trys to connect it won't allow him to connect, unless i clear the crypto isakmp. Then he is able to connect but then the other users are not. I turned on debug to see what going on. can someone help!

3 REPLIES

Re: VPN: Having problems allowing multiple connections

Hi Eddie,

Issue command sh ver and check if you have enough VPN peer license.

Regards

New Member

Re: VPN: Having problems allowing multiple connections

husycisco,

This was the results of the 'sh ver'

It say's IKE peers Unlimited so I think I do

Cisco PIX Firewall Version 6.3(3)

Cisco PIX Device Manager Version 3.0(1)

Compiled on Wed 13-Aug-03 13:55 by morlee

CCX up 7 hours 18 mins

Hardware: PIX-506, 32 MB RAM, CPU Pentium 200 MHz

Flash i28F640J5 @ 0x300, 8MB

BIOS Flash AT29C257 @ 0xfffd8000, 32KB

0: ethernet0: address is 0050.54ff.b821, irq 11

1: ethernet1: address is 0050.54ff.b822, irq 10

Licensed Features:

Failover: Disabled

VPN-DES: Enabled

VPN-3DES-AES: Disabled

Maximum Physical Interfaces: 2

Maximum Interfaces: 2

Cut-through Proxy: Enabled

Guards: Enabled

URL-filtering: Enabled

Inside Hosts: Unlimited

Throughput: Limited

IKE peers: Unlimited

This PIX has a Restricted (R) license.

Serial Number: 480350848 (0x1ca19280)

Running Activation Key: 0xd0ca14d7 0xd9505ca8 0x029ca1e2 0x28f92281

Configuration last modified by enable_15 at 08:44:40.216 MST Thu Feb 7 2008

Re: VPN: Having problems allowing multiple connections

Eddie,

I suggest you to upgrade your IOS to 6.3(5) first. Second, make sure you have isakmp nat-traversal 20 issued in config

101
Views
0
Helpful
3
Replies