This is not possible. If you set your outside interface IP to (lets say) 22.214.171.124/30 and then try to set your inside interface to 126.96.36.199 you will get an error message stating something like it is already assigned to another interface (don't remember the exact message). So you would have to have different IP addresses for each interface on the ASA (that includes subinterfaces.
In transparent mode you can set one management interface IP that will be on the same subnet as both your inside and outside networks.
Please remember to select a correct answer and rate helpful posts
Please remember to rate and select a correct answer
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
[toc:faq]Introduction:This document describes details on how NAT-T
works.Background:ESP encrypts all critical information, encapsulating
the entire inner TCP/UDP datagram within an ESP header. ESP is an IP
protocol in the same sense that TCP and UDP are I...