I had an ASA5505 running OK with port mapping for few servers from the outside interface to the inside to enable remote desktop.
I then added the commands necessary to enable WAN failover though another ISP. once I had this running and tested OK, port mapping stopped working.
I have verified that I am still on the main ISP when we tried remote desktop (since I haven't added the necessary lines yet).
Attached is the current configuration (with WAN failover working but not port mapping). Just to confirm, I haven't made any changes to port mapping so it should still run if we are still on the main (old) ISP with no change in IP addressing.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...