Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

Wants to allow single IP to access to the PIX

I have PIX 506e with software version 6.1(4). By default access to PIX is diabled. But I want to give access to the perticular single IP to the PIX. What commands should I configured on PIX or how should I do?

1 REPLY
Gold

Re: Wants to allow single IP to access to the PIX

It looks you mean management access

there are two ways ssh/telnet and https(via PDM)

If you need access only for address x.x.x.x (located on inside)

ssh x.x.x.x 255.255.255.255 inside

if you want restrict https access

http x.x.x.x 255.255.255.255 inside

Following links could be helpful

http://www.ciscopress.com/articles/article.asp?p=25342&rl=1

http://www.cisco.com/warp/public/110/authtopix.shtml

m.

Hope that helps rate if it does

225
Views
0
Helpful
1
Replies
CreatePlease to create content