Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Websense PIX 515 Configuration

Hello all,

In need of some websense and firewall help. We have purchased a new Websense 10000 Appliance and I'm not a hundred percent how to set this up. I see that URL Filtering is a possibility and WCCP can anyone recommend which way to move forward on implementing this?

Do both of these protocols use a span port on the connected switch on the appliance to monitor traffic?

Any help would be much appreciated.....

Thanks,

Dan

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Red

Websense PIX 515 Configuration

Hi Dan,

You can refer this doc, it explains everything:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a008088517b.shtml

Thanks,
Varun Rao
Security Team,
Cisco TAC

Thanks, Varun Rao Security Team, Cisco TAC
4 REPLIES
Red

Websense PIX 515 Configuration

Hi Dan,

You can refer this doc, it explains everything:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a008088517b.shtml

Thanks,
Varun Rao
Security Team,
Cisco TAC

Thanks, Varun Rao Security Team, Cisco TAC
Community Member

Websense PIX 515 Configuration

Thank you Varuna, is the pix515 able to use wccp as its redirect?

Thanks,

Dan

Community Member

Websense PIX 515 Configuration

If you are running Websense, it would be best to use the document the TAC engineer listed above. If you are running version 7.02 or later on the PIX, WCCP is available.  WCCP is generally used to redirect traffic to an Ironport device.

Community Member

Websense PIX 515 Configuration

Does that also include using transparent identification via websense? We are wainting to intergrate it with our active directory so it can pull policy via AD groups. I thought that WCCP was needed for that.

thanks,

Dan

509
Views
0
Helpful
4
Replies
CreatePlease to create content