Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Weird Behavior from New Code


Hi,

We just upgraded from 8.2.4 to 8.2.5.20 on each firewall. The Primary and Secondary work when they are standalone but, when we connect the fail over link from the Primary to the Secondary, invariably, one of them will go into a constant boot cycle and one will be active but, external users will be intermittently dropped. As soon as we unplug the fail over, the firewall that stays up behaves normally. Has anyone seen this with the 8.2.5.20 code or any other code for that matter?

Thanks, Pat.

2 REPLIES
Cisco Employee

Weird Behavior from New Code

Hi Pat,

Based on your description I would suspect this is caused by CSCtx03464, which only affects 8.2.5.20. However, please open a TAC case to confirm for sure.

-Mike

Community Member

Weird Behavior from New Code

We rolled back to 8.2.5.19 and all is good.

392
Views
5
Helpful
2
Replies
CreatePlease to create content