Cisco Support Community
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

What is the difference between IPS, IDS and a firewall?

What is the difference between IPS, IDS and a firewall?

Everyone's tags (3)
Hall of Fame Super Silver

What is the difference between IPS, IDS and a firewall?

The terms aren't precisely defiend in standards; but in general usage, here is a breakdown:

IPS - Intrusion Prevention System - inspects traffic flowing through a network and is capable of blocking or otherwise remediating flows that it determines are malicious. Usually uses a combination of traffic and file signatures and heuristic analysis of flows.

IDS - Intrusion Detection System - similar to IPS but does not affect flows in any way - only logs or alerts on malicious traffic.

Firewall- prevents or allows traffic between interfaces based on configured rules. Often have a network address translation function to isolate private (RFC 1918) network addresses from public ones. May inspect traffic for conformance with proper protocol behavior and drop non-compliant traffic. Firewalls often have an optional IDS/IPS component based on their usually being placed at the optimal network location to see all interesting traffic that should be subject to further inspection and analysis as is done by IDS/IPS.

Hope this helps.

What is the difference between IPS, IDS and a firewall?

Hello Ranji,

I would like to add some more information about it that might help


Intrusion Prevention System that receives traffic in such a way that can prevent it from reaching the different targets on your network.

As Marvin said works with Signatures written with high level Regex Patterns in order to identify known threaths.

It also provideds the heuristic analysis of low by sitting inline and seeing all traffic during an amount of time defined by the user where the IPS will build a database about what is known to be Traffc in order and when traffic might be Out of Order.


Security Network Appliance in charge of monitor the network and determine whether or not an attack is in place.

Does not prevent the attack from reaching the different assets (altough there are some options to configure it to send RST packets on some platforms).

It does NOT receives the real traffic from client to server or server to client, it basically receives a copy from the network device attached to it (PC,SPAN session, TAP, Packet Brocker,etc)


The Network Security Appliance for Excellence.

Now days not just in charge of inspectioning trafic at level 3-4 and basic level 7 but actually going from level 2 to the Deep contents of the packets at layer 7 (Known as Next Generation Firewalls).

It's main function is to filter traffic through the network while still allowing some traffic to go through.

Remember that now days the Firewalls come with pre-built IPS engines (known as the UTM generation firewalls or Unified Threath Management) such as the Cisco ASA CX, SRXs, CheckPoints and one of the most valuable todays Palo Alto Firewalls.

Looking for some Networking Assistance? 
Contact me directly at

I will fix your problem ASAP.


Julio Carvajal Segura

Julio Carvajal
Senior Network Security and Core Specialist

What is the difference between IPS, IDS and a firewall?

Agreed with Marvin and Julio.

Community Member

Agree on it. could you please

Agree on it. could you please provide me the configuration docs of IPS/IDS.

Hall of Fame Super Silver

Configuration Guides are

Configuration Guides are found on the various product support pages.

FirePOWER Management Center:

Cisco IPS (discontinued product):

Community Member

I have to configure cisco IPS

I have to configure cisco IPS 7000 series. Do you know any setup and configurations docs.

Thanks for your help.

Hall of Fame Super Silver

There are literally dozens of

There are literally dozens of docs.

Start on the Product Support Page:

CreatePlease to create content