Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

why isn't this config working?

I can't ping out on the asa, but I called AT&T to verify the pppoe login info. I am not liking 9.1.


: Saved
:
ASA Version 9.1(3)
!
hostname Hubbard
domain-name DOMAIN.COM
enable password C8300znpCj0V/.zS encrypted
xlate per-session deny tcp any4 any4
xlate per-session deny tcp any4 any6
xlate per-session deny tcp any6 any4
xlate per-session deny tcp any6 any6
xlate per-session deny udp any4 any4 eq domain
xlate per-session deny udp any4 any6 eq domain
xlate per-session deny udp any6 any4 eq domain
xlate per-session deny udp any6 any6 eq domain

names
ip local pool Hubbard 172.26.13.20-172.26.13.25 mask 255.255.255.240
!
interface Ethernet0/0
switchport access vlan 2
!
interface Ethernet0/1
!
interface Ethernet0/2
!
interface Ethernet0/3
!
interface Ethernet0/4
!
interface Ethernet0/5
!
interface Ethernet0/6
!
interface Ethernet0/7
!
interface Vlan1
nameif inside
security-level 100
ip address 172.26.13.17 255.255.255.240
!
interface Vlan2
nameif outside
security-level 0
pppoe client vpdn group ATT
ip address PUBLICIP 255.255.255.248
!
boot system disk0:/asa913-k8.bin
ftp mode passive
dns server-group DefaultDNS
domain-name DOMAN.COM
object network obj_any-01
object network obj-remote
subnet 192.168.47.0 255.255.255.0
object network obj-inside
subnet 172.26.13.16 255.255.255.240
object network obj-172.26.13.16
subnet 172.26.13.32 255.255.255.240
object network obj-192.168.47.0
subnet 192.168.47.0 255.255.255.0
object network obj-172.26.13.96
subnet 172.26.13.96 255.255.255.240
object service WWW
service tcp source eq www
object network inside-host
host 172.26.13.18
object service 48808
service udp source eq 48808
object service 48806
service udp source eq 48806
object network inside-host2
host 172.26.13.19
object network obj-PUBLICIP2
object network medina
host 172.23.13.19
object-group network 192.168.47.0
network-object 192.168.47.0 255.255.255.0
object-group network 172.26.13.16
network-object 172.26.13.16 255.255.255.240
object-group network 0.0.0.0
network-object 0.0.0.0 0.0.0.0
object-group network 192.168.40.0
network-object 192.168.40.0 255.255.255.128
access-list inside_nat0_outbound extended permit ip 172.26.13.16 255.255.255.240 192.168.47.0 255.255.255.0
access-list inside_NAT_outbound extended permit ip 172.26.13.16 255.255.255.240 any4
access-list 147 extended permit ip 172.26.13.16 255.255.255.240 192.168.47.0 255.255.255.0
access-list 130 extended permit ip 172.26.13.16 255.255.255.240 192.168.40.0 255.255.255.128
access-list 148 extended permit ip 172.26.13.16 255.255.255.240 172.26.13.96 255.255.255.240
pager lines 24
logging asdm informational
mtu inside 1500
mtu outside 1492
icmp unreachable rate-limit 1 burst-size 1
asdm image disk0:/asdm-524.bin
no asdm history enable
arp timeout 14400
no arp permit-nonconnected
nat (inside,outside) source static obj-172.26.13.16 obj-172.26.13.16 destination static obj-172.26.13.96 obj-172.26.13.96
nat (inside,outside) source static inside-host interface service 48806 48806
nat (inside,outside) source static inside-host interface service 48808 48808
nat (inside,outside) source static inside-host interface service WWW WWW
!
object network medina
nat (inside,outside) static OUTSIDEIP2
!
nat (inside,outside) after-auto source dynamic obj-172.26.13.16 interface
route outside 0.0.0.0 0.0.0.0 GATEWAY 1
timeout xlate 3:00:00
timeout pat-xlate 0:00:30
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute
timeout tcp-proxy-reassembly 0:01:00
timeout floating-conn 0:00:00
dynamic-access-policy-record DfltAccessPolicy
user-identity default-domain LOCAL
aaa authentication ssh console LOCAL
http server enable
http 172.26.13.16 255.255.255.240 inside
http 192.168.1.0 255.255.255.0 inside
no snmp-server location
no snmp-server contact
crypto ipsec ikev1 transform-set MYSET esp-des esp-md5-hmac
crypto ipsec security-association pmtu-aging infinite
crypto map TUNNEL_MAP 45 match address 147
crypto map TUNNEL_MAP 45 set peer HOUSTON
crypto map TUNNEL_MAP 45 set ikev1 transform-set MYSET
crypto map TUNNEL_MAP 46 match address 130
crypto map TUNNEL_MAP 46 set peer DALLAS
crypto map TUNNEL_MAP 46 set ikev1 transform-set MYSET
crypto map TUNNEL_MAP interface outside
crypto ca trustpool policy
crypto isakmp identity address
no crypto isakmp nat-traversal
telnet timeout 5
ssh 0.0.0.0 0.0.0.0 inside
ssh 0.0.0.0 0.0.0.0 outside
ssh timeout 5
ssh key-exchange group dh-group1-sha1
console timeout 0
vpdn group ATT request dialout pppoe
vpdn group ATT localname AT&TEMAILADDRESS
vpdn group ATT ppp authentication pap
vpdn username AT&TEMAILADDRESS password *****

dhcpd address 172.26.13.19-172.26.13.22 inside
dhcpd enable inside
!
threat-detection basic-threat
threat-detection statistics access-list
no threat-detection statistics tcp-intercept
username admini password jBFrHOlRmYIzGm8t encrypted
tunnel-group DALLAS type ipsec-l2l
tunnel-group DALLAS ipsec-attributes
ikev1 pre-shared-key *****
tunnel-group HOUSTON type ipsec-l2l
tunnel-group HOUSTON ipsec-attributes
ikev1 pre-shared-key *****
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map type inspect dns preset_dns_map
parameters
message-length maximum client auto
message-length maximum 512
policy-map global_policy
class inspection_default
inspect dns preset_dns_map
inspect ftp
inspect h323 h225
inspect h323 ras
inspect rsh
inspect rtsp
inspect esmtp
inspect sqlnet
inspect skinny
inspect sunrpc
inspect xdmcp
inspect sip
inspect netbios
inspect tftp
inspect ip-options
!
service-policy global_policy global
prompt hostname context
no call-home reporting anonymous
call-home
profile CiscoTAC-1
no active
destination address http https://tools.cisco.com/its/service/oddce/services/DDCEService
destination address email callhome@cisco.com
destination transport-method http
subscribe-to-alert-group diagnostic
subscribe-to-alert-group environment
subscribe-to-alert-group inventory periodic monthly
subscribe-to-alert-group configuration periodic monthly
subscribe-to-alert-group telemetry periodic daily
Cryptochecksum:921fb18d896538430aef7516d4f0e65d
: end

Sent from Cisco Technical Support iPhone App

2 REPLIES

Re: why isn't this config working?

hi jordan,

was it working prior upgrading to 9.1?

could you do below and kindly post show interface ip brief?

policy-map global_policy

class inspection_default

inspect icmp

VIP Green

Re: why isn't this config working?

Could you run the following packet-tracer to see if the ASA is hitting any snags
Please post the output here

packet-tracer input inside tcp
172.26.13.18 12345 4.2.2.2 80 detail
-- Please remember to rate and select a correct answer
218
Views
0
Helpful
2
Replies