07-25-2013 01:18 PM - edited 03-11-2019 07:17 PM
Hi Everyone,
I need to add ASA which is in production to CSM 4.3 using Add Network device method.
My concern is this ASA is in multicontext mode and if i add this to CSM will it remove or change any config on ASA??
As i am doing this first time so i do not want to create any outage.
Regards
MAhesh
Solved! Go to Solution.
07-26-2013 12:33 PM
It will not erase anything,
Just make sure you discover all contexts and policies at the same time; otherwise, you will have to discover policies for each context separately.
For Networking Posts check my blog at http://www.laguiadelnetworking.com/category/english/
Cheers,
Julio Carvajal Segura
For Networking Posts check my blog at http://www.laguiadelnetworking.com/category/english/
Cheers,
Julio Carvajal Segura
07-26-2013 12:33 PM
It will not erase anything,
Just make sure you discover all contexts and policies at the same time; otherwise, you will have to discover policies for each context separately.
For Networking Posts check my blog at http://www.laguiadelnetworking.com/category/english/
Cheers,
Julio Carvajal Segura
For Networking Posts check my blog at http://www.laguiadelnetworking.com/category/english/
Cheers,
Julio Carvajal Segura
07-26-2013 12:40 PM
Thanks Julio
Regards
MAhesh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide