Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ZBPF and SDM

I am configuring Zone Based Policy Firewall using SDM . As per my knowledge if you use an older version of SDM or IOS you will get CBAC there in SDM but starting IOS 12.4(6)T that feature would be replaced with ZBPF which has got zones rather than those ACL . However when I am going to Configure - Firewall - Basic/Advance and when i Finish up with the configuration I cee that CBAC has been applied .

I am using SDM v2.5

and I have tried the following IOS

c2691-advsecurityk9-mz.124-6.T

c2600-advsecurityk9-mz.124-15.T3

c2600-adventerprisek9-mz.124-15.T9

Feature nagivator says that these both IOS supports ZBPF but I am not getting them in SDM .

Note: I am using GNS3 to emulate these stuff

Kindly help

2 REPLIES
Cisco Employee

Re: ZBPF and SDM

New Member

Re: ZBPF and SDM

Thanks Soares ,

                       It looked like it was a problem with GNS3 , I tested the same stuff in my office PC and everything worked fine .

BIG FAT WARNING : NEVER RELY ON EMULATORS

cb,

281
Views
0
Helpful
2
Replies