Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Zone based firewall - cannot assign interface to zone

Hi

I have a weird problem .

I want to configure a zone based firewall but i have the folowing problem

I have a router who performs router o a stick and a WAN connection .

From the CCP GUI when i click add a zone i don`t see the interface GigabitEthernet0/1 to choose from the list. (see the printscreen)

GigabitEthernet0/0         217.xxx.xxx.xxx  YES NVRAM  up                    up 

GigabitEthernet0/1         192.168.1.1     YES NVRAM  up                    up 

GigabitEthernet0/1.10      10.10.10.1      YES NVRAM  up                    up 

zonegui.png

Any ideeas ?

Thanks

1 REPLY
Hall of Fame Super Silver

Zone based firewall - cannot assign interface to zone

I believe that both 192.168.1.1 and 10.10.10.1 need to be configured on their respective subinterfaces. Make a subinterface like Gi0/1.1 and assign it the 192.168.1.1 address instead of the parent interface.

297
Views
0
Helpful
1
Replies