Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Zone Based firewall issue

I have an 1811 with an old cfg on it. i want to update it to use zone based rules.

However the SDM is telling me that the legacy firewall is in place, and I need to remove them.

i am a security nad routing newbie. Can some one point me in the right direction ?

I have attached the relevent parts

1 REPLY
New Member

Re: Zone Based firewall issue

To enable SDM to configure ZBF, you need to remove ip inspect rule that is associated to all interfaces in router.

Refresh SDM, you will see ZBF UI.

178
Views
0
Helpful
1
Replies