ERR-DISABLE

[vivanet36753125]

Olá todos,

Estou com um problema em um roteador cisco, no boot em BOOTUP_TEST_FAIL está desabilitando as 1 a 12 de 24 postas. o roteador consiste de uma supervisora ws-720-3bxl e um modulo ws-x6724-sfp, quando realiza o test diagnostico o sistema desabilita por Err_disable as portas, não tenho a verção mais atual desta supervisora mais já tentei atualizar en una verção superior a da mesma mais sem exido

CONST_DIAG-SP-3-BOOTUP_TEST_FAIL: Module 3: TestLoopback failed on port(s) 1-12g

: %CONST_DIAG-SP-3-BOOTUP_TEST_FAIL: Module 3: TestLoopback failed on port(s) 1-12
*Jun 11 23:58:04.803: %CONST_DIAG-SP-3-BOOTUP_TEST_FAIL: Module 3: TestIPv6FibShortcut failed
*Jun 11 23:58:04.803: %CONST_DIAG-SP-3-BOOTUP_TEST_FAIL: Module 3: TestIngressSpan fail ed
*Jun 11 23:58:04.803: %CONST_DIAG-SP-3-BOOTUP_TEST_FAIL: Module 3: TestAclPermit failed
*Jun 11 23:58:04.803: %CONST_DIAG-SP-3-BOOTUP_TEST_FAIL: Module 3: TestAclDeny failed
*Jun 11 23:58:05.731: %OIR-SP-3-LC_FAILURE: Module 3 has Major online diagnostic failur e, Card will be reset to re-run diagnostic. Please check sup-bootflash diaginfo file fo r previous detailed diagnostic result.
*Jun 11 23:58:05.731: %OIR-SP-3-PWRCYCLE: Card in module 3, is being power-cycled 'off (Diagnostic Failure)'

[Ruben Cocheno]

Parecem ser erros de hardware, recomendo abrir um caso na Cisco para o efeito.

TestLoopback

This test verifies the data path between the supervisor engine and the network ports of a module. In this test, a Layer 2 packet is flooded onto a VLAN that consists of only the test port and the supervisor engine's inband port. The packet loops back in the port and returns to the supervisor engine on that same VLAN.

Attribute	Description
Disruptive or Nondisruptive:	Disruptive for looped-back ports. Disruption is typically less than one second. Duration of the disruption depends on the configuration of looped-back port (for example, Spanning Tree Protocol).
Recommendation:	Schedule during downtime.
Default:	Runs at bootup or after online insertion and removal (OIR).
Intitial Release:	12.2(14)SX.
Corrective action:	Error disable a port if the loopback test fails on the port. Reset the module if all of the ports fail.
Hardware support:	All modules including supervisor engines.