Can anyone tell me how to clear the (Boot) after hostname on IOS 11.2 2500 router. We took a power hit on this router and After rebooting it has (Boot) after the hostname. Router is working fine with no problems !!
I doubt that there is anything you can do about this remotely. I have seen symptoms like this a few times where memory was not well seated (the router had been moved) and re-seating the memory cleared it up. But that is not a remote operation. And if the router was running ok up to the power hit it seems less likely to be a candidate for reseating. It sounds to me like the router is a prime candidate for replacement.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...